Open Source Tools: Part Three (Even more nmap options)

nmap optionsWhen you specify your targets for scanning, nmap will accept specific IP addresses, address ranges in CIDR format, and octet format (i.e. x.x.x.x). If you have a host file, which may have been generated from your ping sweep earlier, you can specify it as well using the -iL flag. There are other, more formal nmap parsing programs out there, but awk can be used to create a quick and dirty hosts file from an nmap ping sweep. Scripting can be a very powerful addition to any tool, but remember to check all the available output options to avoid doing too much work.

nmap allows the user to specify the speed of the scan, or the amount of time from probe sent to replay received, and therefore how fast packets are sent. On a fast LAN, you can optimize your scanning by setting the -T option to 4, or Aggressive, usually without dropping any packets during send. If you find that a normal scan is taking very long due to ingress filtering or a firewall device, you may want to enable Aggressive scanning. If you know that an IDS sits between you and the target, and you want to be as stealthy as possible, the using -T0 or Paranoid should do what you want; however, it will take a long time to finish a scan, perhaps several hours, depending on your scan parameters.

By default, nmap 6.40 with Auditor scans 1000 ports for common services, which will catch most open TCP ports out there. However, sneaky sysadmins may run ports on uncommon ports, practicing security through obscurity. Without scanning those uncommon ports, you may be missing these services. If you have time, or suspect that a system may be running other services, run nmap with the -p1-65535 parameter, which will scan all 65k TCP ports. Even on a LAN with responsive systems, this will take anywhere from 30 minutes to a few hours. Performing a test like this over the Internet may take even longer, which will allow more time for the system owners, or watchers, to note the excessive traffic and shut you down.

Ping Sweeping with netenum

Finally, if you have a need for a very simple ICMP ping sweep program that you can use for scriptable applications, netenum might be useful. It performs a basic ICMP ping and then replies with only the reachable targets. One quirt about netenum is that it requires a timeout to be specified for the entire test. If no timeout is specified, it outputs a CR-delimited dump of the inputted addresses. If you have tools that will not accept a CIDR formatted range of addresses, you might use netenum to simply expand that into a listing of individual IP addresses. netenum is part of the Internetwork Routing Protocol Attack Suite, which also includes such utilities as cdp (for sending Cisco router Discovery protocol messages), and ass (Automated System Scanner).

External Links:

The official nmap site

Official site for the Internetwork Routing Protocol Attack Suite (IRPAS) – netenum is part of IRPAS

Be Sociable, Share!

Speak Your Mind


© 2013 David Zientara. All rights reserved. Privacy Policy